![]() As a result, it turns out that at the same time the bay is turned on (the water inlet valves are open) and the water drain (theĬheck the reliability of the connection between the electronic controller and the level sensor, as well as the sensor itself. In thisĬase, water is poured into the CM tank to the level of "TRANSEL". Replace the electronic module of the washing machineį02 The signal from the tacho sensor about the rotation of the drive motor is not fed to the electronic controllerĬheck the contacts of the CNE connector on the electronic module of the washing machineĬheck the connection between the motor and the electronic module.į03 The temperature sensor is faulty, or the heater water heater relay is "hot"Ĭheck the contacts of the CAN connector on the electronic module.Ĭheck the integrity of the wires from the sensor to the connector.į04 The water level sensor (pressure switch) is faulty The water level sensor simultaneously generates the signals "FAN" and "EMPTY TANK" (although only "EMPTY TANK" should be generated). Error code Error code interpretation Probable malfunction of the washing machineį01 Short circuit in the control circuit of the CM drive motorĬheck the connection of the electronic module of the washing machineĬheck the contacts and the presence of water.Ĭheck the motor connection for mechanical damage to the wire breakage. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |